ATN Update Center

Please sign in to download firmware. Sign up to receive notifications about latest firmware for your device.

File is downloading now. If download is not begin automaticly, please use this link

New Features:

  • New sleep mode
  • Media gallery

Improvements:

  • Ballistic calculation improvement
  • Stop record when there is no empty space on SD card
  • Improved functionality
Device models: BinoX-HD 4-16x

New Features:

  • Media gallery (if HDMI connected, you have to disconnect HDMI before close the media gallery)
  • Sleep mode

Improvements:

  • Added External power supply indicator

Fixed bugs:

  • Fixed - Incorrect displayed value in the distance widget
  • Fixed - IR LED was ON all the time
  • Fixed - Periodic hanging while in gallery
  • Fixed - Unable to stop the video recording when battery gets too low
  • Fixed - Two icon "WIFI" in shortcut menu
  • Fixed - Night Mode / German Language for BinoX

New Features:

  • New Sleep Mode
  • Media Gallery

Improvements:

  • Ballistic calculation improvement
  • System Automatically ends recording when no storage space is left

Fixed bugs:

  • Fixed - Device hangs when you turn on RAV+GPS+HDMI
  • Fixed - Device hangs when inputting values in BC while on maximum extended zoom
  • Fixed - Device hangs when you use Zero Reticle
  • Fixed - Remote controller doesn't reconnect
  • Fixed - Photo differ in Burst Count and Single Count
  • Fixed - Device hangs in the Gallery
  • Fixed - Zoom Widget - "error" and not displaying Zoom Value
  • Fixed – Device hangs when recording in time lapse session
Device models: X-Spotter HD 20-80X

New Features:

  • New sleep mode
  • Media gallery

Improvements:

  • Stop record when there is no empty space on SD card
  • Improved functionality

SMART HD FIRMWARE UPDATE

Download firmware for digital rifle scopes and binoculars (firmware being the built-in software that runs your devices). Before proceeding please read instructions below. No downloads are available for products that are not listed.

IMPORTANT NOTICE: Firmware specific to your device - install only. Installing the wrong firmware could damage your unit and/or void the warranty.

UPDATE INSTRUCTIONS

  1. Download the ***.bin file from https://www.atncorp.com/firmware You may need to create an account if you didn't create it earlier, and copy to your microSD Card — root directory.
  2. Insert the card into the scope.
  3. Turn ON the scope.
  4. In the "Firmware Update" dialog box select "Yes" to start the update.
    ​If the device does not restart within 30 seconds after reaching 100%, remove and re-insert the batteries​ and​ power-up the device.​
  5. When the update counter reaches "100%", the device will automatically restart.
    You must make sure that the batteries in the device are fully charged before updating. In the event of a power failure during an updated the device may need to be sent back to the factory for service.
  6. Once the device is powered up, it will enter self configuration mode.
  7. After completing it will automatically restart and will be ready for use.
  8. Motion Sensing platform will be configured when first turned on.
  9. Once the Firmware update completes, please do a factory reset before using the product.
  10. Please remember to delete the Firmware File off of the microSD card after all steps are completed.